Convert Point (pt) to Mil (mil) instantly.
Point to Mil conversion
1 Point (pt) = 13.88889 Mil (mil). To convert Point to Mil, multiply the value by 13.88889.
| Point (pt) | Mil (mil) |
|---|---|
| 1 | 13.88889 |
| 2 | 27.77778 |
| 5 | 69.444449 |
| 10 | 138.8889 |
| 25 | 347.22224 |
| 50 | 694.44449 |
| 100 | 1388.889 |
| 1000 | 13888.89 |
Frequently asked questions
How many Mil are in one Point?
One Point (pt) equals 13.88889 Mil (mil).
How do I convert Point to Mil?
To convert Point to Mil, multiply the value by 13.88889.
What is 10 Point in Mil?
10 Point = 138.8889 Mil.
About these units
Point (pt)
A point is a typographic unit traditionally equal to 1/72 of an inch (in digital typography) or 0.352777 mm. Historically, however, the point system varied widely across regions and printing houses. In the era of metal movable type, each foundry often produced its own proprietary sizes, making typefaces and point values incompatible between printers. The modern point was standardized largely due to the demands of the publishing industry and later digital systems, especially PostScript and desktop publishing software. The point became essential because typography requires extremely fine control over letter height, line spacing, and layout—far beyond what conventional measurement systems could easily express. Designers and typesetters rely on points to specify the sizes of fonts, the spacing between lines (leading), and the thickness of rules or strokes. In digital environments, the point remains foundational even though screen resolutions vary. Software uses points as virtual units that are converted into pixels depending on display density. Thus, the point bridges the traditional world of print with modern digital rendering, maintaining continuity in the long history of written communication.
Mil (mil)
A mil is an imperial-derived engineering unit equal to one-thousandth of an inch. It is used extensively in manufacturing, machining, and electrical engineering. Printed circuit board (PCB) trace widths, for instance, are often measured in mils because the unit provides a convenient scale for precision without resorting to decimals in inches. Because 1 mil equals 25.4 micrometers, it occupies a scale appropriate for tolerances in industrial production, coatings, film thickness, and gaskets. The mil is especially common in the United States, where certain engineering standards still rely on the imperial system. It provides an intuitive small-scale measurement for technicians accustomed to inches, helping avoid errors that might result from metric conversions.